Emerson Epsilon Eb Digital Servo Drive Manual de Instalação descarregar pdf (Página 40)

Epsilon Eb Digital Servo Drive Installation Manual

Figure 19: Epsilon I/O to Command Connector Internal Connections

Note

If loads are applied to the same output signal on both Command Connector and I/O

Connector, the sum total current loading must be limited to 150 mA per output signal.

Command Connector Wiring

All command and digital I/O signals are available using the 44-pin Command Connector.

If you are interfacing your drive(s) to an AXIMA 2000 or 4000 multi-axis controller, simply

connect the 44-pin connector of your AX-CEN-XXX cable to the drive and the 25-pin

connector to the AXIMA multi-axis controller.

If you are interfacing your drive(s) to an AXIMA or any other motion controller, you may use

either the CDRO-XXX or CMDO-XXX cables or the optional External Connection Interface

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 99 100

Sem comentários

Emerson Epsilon Eb Digital Servo Drive Manual de Instalação Página 40