Emerson RUSTICO CF160 Manual do Utilizador

Part No. F40BP73580001 Form No. BP7358-1U.L. Model No.: CF160READ AND SAVE THESE INSTRUCTIONSNet Weight: 30.6 Lbs.RUSTICO™Ceiling FanOwner's Ma

NOTE: If you wish to operate your ceil-ing fan with the downlight fixtureattached, perform steps 7 and 8.Otherwise, skip to step 9.7. For Operating Yo

10. Screw in three 60-watt (maximum)candelabra base bulbs into the lightfitter sockets (Figure 18). Remove andretain the nut and rubber washer fromthe

12Operating YourCeiling FanIMPORTANTFan installation must be completed,including the installation of the fanblades, before testing of the remotecontro

13Do not use water when cleaning yourceiling fan. It could damage themotor or the blades and create thepossibility of an electrical shock.!WARNINGThe

14Trouble ShootingTROUBLE PROBABLE CAUSE SUGGESTED REMEDY1. Fan will not 1. Fuse or circuit breaker 1. Check main and branchstart. blown. circuit fu

15Repair Parts ListingPart NumberKey Model No.No. Description CF160RTI00* Hanger Pack, Consisting of: 761655-371 Hanger Bracket —2 Hanger Ball —3 Down

LIMITED WARRANTYWhat The Warranty Covers:This warranty covers the motor and the other components and accessories of your Emerson ceiling fan against a

WARNING: To avoid fire, shock, and serious personal injury, follow theseinstructions.Safety Instructions1. Read your owner’s manual carefully and kee

3Tools Needed for AssemblyOne Phillips head screwdriverOne wire stripperOne stepladderSix wire connectors (supplied)Three 60-watt (max.) candelabra ba

GeneralYour Emerson ceiling fan comes equippedwith a remote control transmitter and aremote control receiver. This remote con-trol systems is designed

2. Slide the four switch levers on the codeswitch to your choice of ON (up) ordown positions. Use a ball-point pen orsmall screwdriver and slide the l

7. Carefully remove the fan motor housingassembly from the lower foam pad.Turn the housing assembly over andposition it on the lower foam pad withthe

tight against the pin and securely tight-en the setscrew in the hanger ball.A loose setscrew could create fanwobble.DOWNRODDECORATIVE COVERGROMMETDECO

2. Carefully lift the fan and seat the hang-er ball/downrod assembly on the hang-er bracket that was just attached to theoutlet box (Figure 11). Be su

91. Position the supply wires to the left sideof the outlet box (Figure 12); positionthe fan wires to the right side. Partiallyinsert the remote contr