Emerson Liebert CW Manual do Utilizador descarregar pdf (Página 31)

Equipment Inspection and Handling

Figure 19 Equipment recommended for handling the Liebert CW

If possible, transport the Liebert CW with a forklift or pallet jacks. If that is not possible, use a crane

with slings and spreader bars.

• If using a forklift or pallet jack, make sure that the forks (if adjustable) are spread to the widest

distance that will fit under the skid.

Ensure the fork length is suitable for the unit length.

• When moving the packaged Liebert CW with a forklift, lift the unit from either end of the skid

that has the indicated labeling no higher than 4" (102mm) off the floor. Ensure that the opposite

end still touches the floor.

• The unit is to be pulled by the forklift—If the unit must be lifted higher than 4" (102mm) great

care must be exercised: Personnel who are not directly involved in moving the unit must be kept

20' (5m) or farther from the lift point of the unit.

• Always refer to the location of the center of gravity indicators when lifting the Liebert CW (see

Figure 23).

4.2 Unpacking the Unit

Remove outer packaging when ready to install the unit.

1. Remove the exterior stretch wrap packaging material from the unit, exposing the protective

corner and side packaging planks.

2. Remove the corner and side packaging planks from the unit, exposing the bag over the unit.

3. Remove the bag from the unit when ready to remove the skid and install the unit.

Figure 20 Removing packaging

Spreader Bars and Slings

Piano Jacks

Pallet

Jack

Forklift

Step 1

196713

Rev. 0

Step 2 Step 3

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 87 88

Sem comentários

Emerson Liebert CW Manual do Utilizador Página 31