Emerson MONITORING OpenComms Manual do Utilizador descarregar pdf (Página 18)

Opening a Web Connection

This section explains the Web interface in detail. From the Web, you can

monitor and control the UPS in which the card is installed. You can also

configure many settings of the card.

NOTE: To specify that the card communicates at either 10Mbit or

100Mbit, instead of it trying to auto-negotiate, you must use the Service

Terminal.

You access the Web Interface of the OpenComms Web Card by opening

a direct web browser. The card utilizes functionality of Microsoft Internet

Explorer 5.0 or higher. Whenever possible, you should use the latest

copy of IE.

1. Open your web browser software.

2. Enter the IP address or hostname of the card in the address line of

your browser.

The first page you will see every time you open a new Web connection to

the card is the Power Flow folder in the monitor tab. After your browser

connects, you will see a screen very similar to below:

Web

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 31 32

Sem comentários

Emerson MONITORING OpenComms Manual do Utilizador Página 18