
80
Rosemount 3051
September 2014
www.rosemount.com
Options
Standard configuration
Unless otherwise specified, transmitter is shipped
as follows:
Custom configuration
(1)
If Option Code C1 is ordered, the customer may specify the
following data in addition to the standard configuration
parameters.
Output Information
Transmitter Information
LCD Display Configuration
Hardware Selectable Information
Signal Selection
Wireless Information
Scaled Variable
and more
Refer to the “Rosemount 3051 Configuration Data Sheet”
document number 00806-0100-4007 for Rosemount 3051 HART
protocol.
For Wireless refer to the “Rosemount 3051 Wireless
Configuration Data Sheet” (document number
00806-0100-4100).
(1)
Tagging (3 options available)
Standard SST hardware tag is wired to the transmitter. Tag
character height is 0.125 in. (3,18 mm), 56 characters
maximum.
Tag may be permanently stamped on transmitter nameplate
upon request, 56 characters maximum.
Tag may be stored in transmitter memory. Character limit is
dependent on protocol.
• HART Revision 5: 8 characters
• HART Revision 7 and Wireless: 32 characters
•F
OUNDATION fieldbus: 32 characters
• PROFIBUS PA: 32 characters
ENGINEERING UNITS
Differential/Gage:
Absolute/3051TA/3051TG:
inH
2
O (Range 0, 1, 2, and 3)
psi (Range 4 and 5)
psi (all ranges)
4 mA
(1)
(1) Not applicable to FOUNDATION fieldbus, PROFIBUS PA, or wireless.
0 (engineering units above)
20 mA
(1)
:
Upper range limit
Output: Linear
External buttons:
None
Flange type:
Specified model code option
Flange material:
Specified model code option
O-ring material:
Specified model code option
Drain/vent:
Specified model code option
LCD Display:
None
Alarm
(1)
: High
Software tag:
(Blank)
Damping:
0.4 seconds
(2)
(2) For fieldbus protocols, default damping is 1 second.
(1) Not applicable to FOUNDATION fieldbus or PROFIBUS PA protocols.
Comentários a estes Manuais