Emerson ROC364 Manual de Instruções descarregar pdf (Página 5)

ROC364 Instruction Manual

Rev 5/00 6-1

Section: 6. — ROC364 I/O Card

6.1 SCOPE

This section describes the 32-point Input/Output (I/O) Card used with the ROC364 Remote Operations

Controller. This section contains the following information.

Information Section Page Number

Product Description 6.2 6-1

Initial Installation and Setup 6.3 6-3

Configuration and Calibration 6.3.1 6-3

Connecting the I/O Channels to Wiring 6.4 6-4

Analog Input Channels 6.4.1 6-4

Analog Output Channels 6.4.2 6-6

Discrete Input Channels 6.4.3 6-6

Discrete Output Channels 6.4.4 6-8

Pulse Input Channels 6.4.5 6-8

Troubleshooting and Repair 6.5 6-10

Analog Input Channels 6.5.1 6-11

Analog Output Channels 6.5.2 6-12

Discrete Input Channels 6.5.3 6-12

Discrete Output Channels 6.5.4 6-13

Pulse Input Channels 6.5.5 6-13

Replacement Procedure 6.6 6-14

Impact on I/O Point Configuration 6.6.1 6-14

Replacing the I/O 6.6.2 6-14

I/O Card Specifications 6.7 6-16

6.2 PRODUCT DESCRIPTION

The ROC364 I/O (Input/Output) Card, shown in Figure Section: 6-1, provides 32 fixed inputs and

outputs for monitoring and control applications. It is used in conjunction with a ROC364 Master

Controller Unit (MCU) that has a FlashPAC (version 2.10C or later) installed.

The card can be used in place of the I/O modules and module racks that are normally used with the

ROC364 MCU. Only one I/O card can be used with an MCU, and an I/O module rack should not be

used between the I/O card and the MCU.

1 2 3 4 5 6 7 8 9 10 ... 19 20

Sem comentários

Emerson ROC364 Manual de Instruções Página 5