Emerson ACE95Jr Manual de Instruções descarregar pdf (Página 6)

Type ACE95JR



Installation arrangements vary, but in any installation

it is important to open and close valves slowly. When

shutting down the system, close the upstream supply

shutoff valve rst. Refer to Figure 3.



Valve parts are subject to normal wear and must

be inspected and replaced as necessary. The

frequency of inspection and replacement of parts

depends on the severity of service conditions and the

requirements of local, state, and federal regulations.

Due to the care Regulator Technologies. takes in

meeting all manufacturing requirements, use only

replacement parts manufactured or furnished by

Regulator Technologies.

All O-Rings, gaskets, and seals should be lubricated

with a good grade of general purpose lubricant and

installed gently rather than forced into position.

Approved lubricant, sealants, and adhesive are

as follows:

: Dow Corning

111

: Loctite

PST #592, Teon

Tape

: Loctite

#222





















Figure 4. Spring Case, Adjusting Screw, and Actuator Cap

W8160

Be certain that nameplates are updated to accurately

indicate any eld changes in equipment, materials,

service conditions, or pressure settings.



1. Visually inspect the unit to ensure tight connections,

tight seals, and safe operation.

2. Observe the blanketing pressure.

3. Inspect the inlet pressure for the proper pressure

(stamped on the valve nameplate).



1. Visually inspect the unit to ensure tight connections,

tight seals, and safe operation.

2. Observe the blanketing pressure.

3. Inspect the inlet pressure for the proper pressure

(stamped on the valve nameplate).

4. Visually inspect valve for any external damage.

5. If there is evidence of leakage or unstable

internal motion, a rebuild with seal replacement

and re-lubrication may be in order.

Dow Corning

is a mark owned of Dow Corning Corporation.

Loctite

is a mark owned of Henkel Corporation.

Teon

is a mark owned of E.I. du Pont de Nemours and Co.

1 2 3 4 5 6 7 8 9 10 11 12

Type ACE95JR 1

Comentários a estes Manuais

Sem comentários

Emerson ACE95Jr Manual de Instruções Página 6

Comentários a estes Manuais

Manuais e produtos relacionados com não Emerson ACE95Jr