Emerson iPro SERIES Informações Técnicas descarregar pdf (Página 14)

Technical Information

D7.21.2/1011/E

14/17

Assign a unique node address to each CoreSense™ diagnostics module using switches 1 through 5.

a. Set the communications baud rate for the module using switch 7. “Off” = 19200 baud, “On” = 9600 baud.

The baud rate for each module should be set to match the rack controller.

b. Set switch 8 to “Off” for no parity, to “On” for even parity.

c. Set switch 9 to “Off” for stand-alone mode, to “On” for network mode. Network mode will generate a

communications error if the rack controller fails to communicate with the device. For stand-alone mode, no

communications are expected so the communication error is blocked.

d. Factory default setting is “On” for dip-switch 10, ie, discharge temperature protection. If you want to

disconnect the discharge temperature sensor, turn off dip-switch 10.

Push the reset button after changing the switch settings.

Ensure that the dip-switch settings on each module match the settings for the selected controller communication

port.

Information in this document is subject to change without notification.

1 2 ... 9 10 11 12 13 14 15 16 17

Sem comentários

Emerson iPro SERIES Informações Técnicas Página 14