
Reference Manual
00809-0600-4026, Rev BA
December 2011
Rosemount Process Radar
A-4
Electrical Installation
For more information see the sections:
“Connect The Wiring” on page 2-6 (5300),
“It is recommended that shielded twisted pair wiring (18-12 AWG) that is
suitable for the supply voltage and approved for use in hazardous areas be
used. For electrical information such as power supply, see diagrams and
drawings for HART
®
, FOUNDATION™ fieldbus, and Modbus on the following
pages.” on page 5-6 (5400)
and section “Electrical Installation” in the Reference Manual.
Output / Input
Configuration
For more information see the sections:
“Configure” on page 2-11 (5300),
“Configure” on page 5-10 (5400),
“Complete the Basic Configuration” on page 3-2 (5300),
“Basic Configuration” on page 6-2 (5400)
and section “Configuration/Start-Up” in the Reference Manual.
Power supply within limits YES NO
- Voltage measured at the terminal at the
transmitter:
Groundings according to manual and to local
regulations
YES NO
Ground check done with multimeter
YES NO
- Voltage measured between - terminal and
ground:
- Voltage measured between + terminal and
ground:
- Resistance measured between transmitter
head external ground terminal and tank
ground terminal:
Is the cable shield connected according to
guidelines in the Reference Manual and to
local regulations?
YES NO
Is the transmitter head external ground
terminal connected according to guidelines in
the Reference Manual and to local
regulations?
YES NO
Type and size of cable used for the
communication:
Is the lid to the terminal compartment
properly closed?
YES NO
Is the product's Ex classification in
accordance with requirements?
YES NO
Comentários a estes Manuais